Ideal for HDTV recordings with Flicker Free operation
DMX input and output
Power linking input and output
Sound Active with 2 Sound Active Modes (1 Without Strobe/1 With Strobe)
Auto Mode with 8 Speed Settings
Smooth Color Mixing
The CUBEecho has absolute ZERO noise - No Fans to make any Noise.
Fade mode with 8 Speed Settings
Manual Color Mix Mode on Push Button Display
Built In Color Macros, Auto & Manual control
16 Digit, 2 Line, Full Text read out Back-Lit LCD Push Button Display
Ability to create & store into memory 5 Custom/manual Colors.
Power In & Power Out (As of 03/29/2013)
Master/Slave
Up to 20 Hours of Battery Life on one charge
Flush Mounted Wireless DMX Antenna recessed to keep the antenna safe
2.4gHz Wireless DMX Receiver that is also a Transmitter (300ft Line of Sight)
simultaneous master signal transmitting from Master to all other lights in range
IR Remote control. Also the Signal Received from the IR Remote can Transmit to the other lights by Wireless DMX.
(Compatible with CUBE5, ElitePar5 & CUBEecho)
Dual Mount Bracket included for hanging or sitting on the floor
Rubber feet for non intrusive lay flat design.
Beam Angle - 45 Degree (Wide Wash)
PHOTOMETRICS: 11,785 LUX @ 1meter (Full Power)
Dimensions (L x W x H) 6.75" x 6.75" x 4.25"
Weight 4.9lbs
Master Slave settings on the CUBEecho MK2 W-DMX
First to make this simple please get two lights in front of you and have all others off. Once you do this the first time you will see how easy it is and you can try with 10-200 lights.
On the back of the CUBEecho MK2 W-DMX There is two red buttons with W-DMX built into the light.
One Button is a “Latching button" you press it in and it will lock in the down position. Then you can press it again and it will pop up.
Other Button is the “Spring button" you can press it down and it springs up when you let go of the button.
Step 1. Make sure all your lights are set to Slave on the push button display settings.
Step 2. On the Slave lights you need to make sure the “Latching button" is popped out.
Step 3. Next you need to press and hold (about 7 seconds) the “Spring button" until the Transceiver Indicator LED is off (Blacked out)
Step 4. Now select a light to make a Master by setting it to Master in the push button display settings.
Step 5. Next on the Master light you press the “Latching button" down.
Step 6. On the Master Light hold the “Spring button" for 2 seconds and release.
(You will see all of the Transceiver Indicator LED blink while connecting and then stay on when connected. This Master light is now connected to all the Slave lights.)
You can now use the Push button display or IR Remote Plus (When IR INFA is set to Enable) to control the lights
Call Now